Date: Mon, 09 Jun 86 17:07:16 From: Bob Larson Subject: Wkermit problems and sugestions The Wkermit command scanner has some problems. If a typo is made in the first word of a command, multiple error messages are displayed. (i.e. "sat baud 9600" will show 3 unrecognised command errors.) "?" will only display after a return, and will place the cursor at the begining rather than the end of the command in question. I also dislike the wkermit startup banner. The default window size is two large for our configuration. (9600 baud port selector connection.) It's to bad the prime can't check the input buffer size and advertise an appropriate size window. Bob Larson Here is make_kermit.cpl: /* Link file for Kermit-R19, generic Prime version of Kermit */ &data bind LO *>OBJ>MAIN LO *>OBJ>KERMIT LO *>OBJ>MSG_INIT LO *>OBJ>SET_VERSION LO *>OBJ>BK_HNDLR LO *>OBJ>TIMEOUT_HNDLR LO *>OBJ>COMND LO *>OBJ>SERVER LO *>OBJ>GENERIC_CMD LO *>OBJ>CHANGE_DIR LO *>OBJ>REC_SWITCH LO *>OBJ>REC_PACKET LO *>OBJ>SEND_SWITCH LO *>OBJ>SEND_PACKET LO *>OBJ>CHKS LO *>OBJ>ACK_SEND_INIT LO *>OBJ>PRS_SEND_INIT LO *>OBJ>SET_PARAMS LO *>OBJ>OPEN_INPUT LO *>OBJ>OPEN_OUTPUT LO *>OBJ>CLOSE_INPUT LO *>OBJ>CLOSE_OUTPUT LO *>OBJ>READ_INPUT LO *>OBJ>WRITE_OUTPUT LO *>OBJ>WRITE_IBUF LO *>OBJ>DISCARD_OUTPUT LO *>OBJ>MATCH_FILE LO *>OBJ>NEXT_FILE LO *>OBJ>CONVERT_FILE LO *>OBJ>SETUP_TRANS_CHAR LO *>OBJ>GET_ATTR LO *>OBJ>GET_DTM LO *>OBJ>GET_LEN LO *>OBJ>XFER_MODE LO *>OBJ>OPEN_LOG LO *>OBJ>CLOSE_LOG LO *>OBJ>LOG_PACKET LO *>OBJ>LOG_INFO LO *>OBJ>UTILITIES LI VAPPLB LI /* dynt trans /* remove /* from start of line if trans dynt needed rdc map kermit_r19.map file kermit_r19 &end -------