Information for ATI Rage 128 Users
Precision Insight, Inc., SuSE GmbH
13 June 2000
- Full support (including hardware accelerated 2D drawing) for 8, 15,
16, 24 bit pixel depths.
- Hardware cursor support to reduce sprite flicker.
- Support for high resolution video modes up to 1800x1440 @ 70Hz.
- Support for doublescan video modes (e.g., 320x200 and 320x240).
- Support for gamma correction at all pixel depths.
- Fully programmable clock supported.
- Robust text mode restore for VT switching.
- Rage Fury AGP 32MB
- XPERT 128 AGP 16MB
- XPERT 99 AGP 8MB
The driver auto-detects all device information necessary to
initialize the card. The only lines you need in the "Device"
section of your xorg.conf file are:
Section "Device"
Identifier "Rage 128"
Driver "r128"
EndSection
or let xorgconfig do this for you.
However, if you have problems with auto-detection, you can specify:
- VideoRam - in kilobytes
- MemBase - physical address of the linear framebuffer
- IOBase - physical address of the memory mapped IO registers
- ChipID - PCI DEVICE ID
- "hw_cursor" - request hardware cursor (default)
- "sw_cursor" - software cursor only
- "no_accel" - software rendering only
- "dac_8_bit" - use color weight 888 in 8 bpp mode (default)
- "dac_6_bit" - use color weight 666 in 8 bpp mode (VGA emulation)
The X11R7.5 driver was originally part of XFree86 4.4 rc2.
The XFree86 4 driver was ported from XFree86 3.3.x and enhanced by:
The XFree86 4 driver was funded by ATI and was donated to The XFree86
Project by:
Precision Insight, Inc.
Cedar Park, TX
USA
The XFree86 3.3.x driver used for the port was written by:
The XFree86 3.3.x driver was funded by ATI and was donated to The XFree86
Project by Precision Insight, Inc. It was based in part on an earlier
driver that was written by:
This early driver was funded and donated to The XFree86 Project by:
SuSE GmbH
Schanzaekerstr. 10
90443 Nuernberg
Germany
http://www.precisioninsight.com
http://www.suse.com